Rooftop decks: Best Construction Practices for rooftop decks Rooftop Deck & Porch but most EPDM membranes can bond directly to a sanded wood underlayment To protect the roofing membrane, set the sleepers on strips of EPDM or
Aug 19, 2012 Before we look at how to build a deck on a flat roof, here's an Ye, the sleepers and decking above just lay on top of the membrane, Pine is not an ideal material for decking – kind of a soft wood and tends to be knotty.
Sep 3, 2017 back; Composite Decking · Deck Hardware · Wood Materials Building a deck over a flat roof is very similar to building a deck over a concrete patio. EPMD rubber membrane over the top of the roof deck for protection against Then, you will install “sleepers” or flat 2x6s laid flat every 16” on top of the
Aug 8, 2017 Since most roof decks are “floating” structures that sit on top of flat You'll need to install a waterproof rubber membrane over the surface where you intend to build the deck. Then, install “sleepers,” or 2×6 sections, to support the decking Choosing sustainably sourced wood and decking is a great option
tive layer of roofing paper between the Dibiten mem- brane and the fill General Information for Roof Decks. |. Specification Dibiten membrane using wood sleepers (supports), an extra strip . Install the top surfacing of concrete and any top.
CONTINUOUS WOOD DECKS: The simplest walk surface is a single wood deck that spans the entire roof. Typical construction might be 2 x 4 sleepers laid on
Sep 10, 2014 Hardwood decking is then fastened to tapered pressure-treated sleepers that rest on I like rubber roofing for this, combined with a floating deck floor. The rubber roofing I've been using for 15 years—a glue-down, 60-mil EPDM membrane from International Diamond Systems— offers several advantages.
of the job is easy. Decking. Over a. Roof. EPDM membrane. Tapered sleeper. 1⁄2-in. fiber people subcontract the roofing work and build the deck themselves.
May 29, 2011 I am taking a 25x25 roof over a garage that was done in decking then tile and leaked. I tore everything up, replaced the wood that needed it and built up of epdm rubber underneath each sleeper where they will sit on top
top of a finished room may gest a “flat” roof design. membrane roof installed over a prop- . unyielding support for the 2x deck sleepers (detail lower left). . wood. A running cap of 2x8 red cedar protects the overall assembly and ties.
Posts on a rooftop deck; new decking on old framing. Maine, responds: I've been building wood decks with safe railings over flat EPDM roofs on the Second, I mount the posts with hardware that bolts to the top of the deck (Figure 1). protruding from the bottom of the sleepers and putting holes in the roof membrane.
Oct 17, 2014 To prevent avoid penetrating the roofing membrane. Railing EPDM is the best choice for most rooftop decks. Careful Rooftop decking attaches to treated wood “sleepers” separated from the roofing by strips of EPDM.
Pedestal supports and preassembled wood tiles simplify installation and maintenance. rested upon wood sleepers placed directly on a poorly installed and leaking To begin, we demolished the old deck and stripped the roofing membrane planned for the new decking to sit a few inches below the top of the parapet.